03 374 5728
CONTACT US
0item(s)

You have no items in your shopping cart.

Dark Star Imports

Product was successfully added to your shopping cart.

Speaker Selector Switch - 2 Way with Volume Control

SKU: SSW-2V

Be the first to review this product

Quick Overview

Speaker Selector Switch - 2 Way with Volume Control


50W RMS maximum power.


Built in protection circuit  allows two pairs of 4 ohm speakers to be used safely.

$164.50

Availability: In stock

Details

 

Speaker Selector Switch - 2 Way with Volume Control


2 way speaker selector switch with volume control.

Features

This switch allows two pairs of speakers to be run from an amplifier with only one set of outputs, or two pairs of speakers from the one speaker cable. The switch allows you to listen to one pair or two pairs at once.  Each pair has a 10 position volume control. The spring clip terminals accept speaker cable up to 14 AWG. 

 

Using the Protection Circuit.

Your Speaker Selection/Volume Control System has an impedance correction circuit. This circuitry assures that your receiver/amplifier monitors a safe operating load when playing 2 speaker pairs simultaneously. Since most receiver/amplifier are not rated for use below a 4 ohm load. You will need to press the PROTECTION button whenever the overall system impedance falls below 4 ohms.

Playing One Pair of Speakers at a Time.


1. Press in the switch 1 or 2 for the desired speakers.
2. Set the PROTECTION button to the out position.
3. Set the receiver/amplifier’s volume control to minimum by turning it fully counterclockwise. Then turn on the receiver / amplifier and set its volume control slightly above the normal listening level.
4. To increase or decrease the remote speaker’s volume, turn the Speaker Selection/Volume Control System volume control clockwise or counterclockwise.

 

Playing Two Pairs of Speakers at a Time.


1. Press in the switches both 1 and 2.
2. If your two pairs of speakers are 8 ohm speakers then set the PROTECTION button to the out position.
3. If your two pairs of speakers are 4 ohm speakers then press the PROTECTION button.
4. Set the receiver/amplifier’s volume control to minimum by turning it fully counterclockwise. Then turn on the receiver/ amplifier and set its volume control slightly above the normal listening level.
5. To increase or decrease the remote speaker’s volume, turn the Speaker Selection/Volume Control System volume control clockwise or counterclockwise.

 

SPECIFICATIONS

 

  • Power Handling:                   50 Watts (RMS) per Channel
  • Attenuation:                            10-Position Control
  • 1st Position (Fully Counterclockwise): Full-Off
  • 2nd and 3rd Position: Attenuate 6 dB Per Step
  • 4th to 9th Position: Attenuate 3 dB Per Step
  • 10th Position: Full On
  • Channel Separation at 1 KHz:  38dB Normal
  • Crosstalk Between Channels at 1 KHz: 50 dB Normal
  • Speaker Terminal Wire Size: 14-22 AWG

 

Additional Information

SKU SSW-2V

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

  1. Be the first to review this product

Write Your Own Review

Only registered users can write reviews. Please, log in or register